BERNINA 830 Firmware V30.16.20

IMPORTANT NOTE:

BERNINA 830's new firmware includes modified standard settings of the thread tension. This might entail that your normally used thread tension be modified too. The standard settings were changed in order to cover a broader thread range, thus enabling improved quality of stitching results. For even further improvement of stitching results, we also recommend to use the straight-stitch plate, part no. 032100.70.01

Before you start downloading the file

1. Check the firmware version of your BERNINA 830:
   This download contains the version 30.16.20.
2. Please: read first the download instructions before you download the firmware.

Check firmware version on your BERNINA 830 sewing machine

Go to the “Setup” of your BERNINA 830 sewing machine by clicking on the soft key:

  
Open the Information section 

Press the "hand" button three times

On the information screen of your BERNINA 830 you will see the firmware version information of your machine.
Does any of the first two (Firmware, Bootloader) versions has a lower value as shown below, an update is recommended. 

Brief information

Release Notes

Requirements (recommended)

• Computer with min. Windows® XP SP2, min. Windows Vista^TM SP1 or Windows® 7 operating system.
• BERNINA 830 sewing machine
• User manual of the BERNINA 830
• empty BERNINA USB-Memory key (more then 128 MB)
• free and available USB-Port on Computer side

Downloads

Previous firmware versions: